#DSC ALARM PANEL WIRING DRESSED PC#
So M1 is actually where the red wire will go on the PC Link board. And now on the PC Link board, try to get a good angle on it here. So you just push that in place all the way just like that.
So we're going to want to put that red wire closest to the red, press it on the board. And on the board, right there in white ink, it says, "Red." So you can see we have the one red wire here. I'll try to get the camera as close as possible so you can see there. So the PC link cable will go from, again, PC Link2. So, there you have it snapped into place, it's not going anywhere. And then we'll line up the holes on the board with those, and they only line up in one direction, so you can't mount it in the wrong direction. So, we'll start by putting our standoffs through the cabinet in the holes that we'll be using to mount the board. I mean, we can put it in other locations and still reach but this is kind of the most out of the way closest location. I mean, you can put it other places but we're going to be connecting from the PC Link2 here to the PC Link here.
The first step for wiring up the communicator is going to be to mount the PC Link board on the side of the cabinet. So let's go to the panel and we'll get started. This portion we're going to go over the wiring for the communicator. Go check that out if you need to do that still. Today's video is part two in our series for the communicators on the DSC PowerSeries NEO.
#DSC ALARM PANEL WIRING DRESSED HOW TO#
How to wire in an CD8080 module into a DSC PowerSeries NEO panel
0 kommentar(er)
